Training mode: guided tutorials
Two complete tutorials that run inside Concurrent Engineering Design: a guide beside your own study tells you what to do and checks that you did it.
Start a tutorial
Open Concurrent Engineering, then the card Training mode. Two tutorials are offered: Mission 237, a constellation of ten PocketCubes that relays LoRa sensor data in Cameroon, and the 3U CubeSat for CO2. Press Start the tutorial. A study of your own opens, apart from your professional studies.
This page needs a free account.
Follow the guide
The guide sits beside the study. Each step explains Why this matters and gives What to do, and it opens the right tab for you. Everything is done in the tool itself, on the screen where the step asks for it.
Check your work
Press Check my work. The guide reads your saved study and says what it found and what is missing. In the Problem, Mission, Risks and Cost and plan parts, press Save first.
Calculate and answer
Some steps ask for a number, for example a period, a link margin or the passes over mission control. The ones about your design are checked against what the platform finds in your own study.
Deliver the report
Each tutorial ends with a simple mission analysis and design report, built from your study in the Report tab and laid out in the style of the ECSS standards. A short quiz closes the tutorial.
- Training mode and professional mode are the same tool. Press Professional mode in the guide, or open one of your other studies, to work without the guide.
- Want to do a tutorial again? Press Start again at the bottom of the guide. Your training study and your steps are cleared and a new study starts. The record that you finished it stays.